Measurement-computing CIO-DDA06 User Manual download pdf (Page 12)

CIO-DDA06 User's Guide Installing the CIO-DDA06

Analog output range switch

The analog output voltage range of each channel can be set with a set of six-position DIP switches. The switch

blocks are located on the board below the calibration potentiometers. The switch blocks are labeled

GAIN 0 to

GAIN 5, and individual switches are labeled 1 through 6. Set the switches for each individual channel as shown

in . Figure 5

Figure 5. Analog output range switch — one per DAC — configured for ±5 V

gure 5

GAIN #

Range

5.0

0-10

0-5

0-2.5

2.5

1.67

(Shown)

To set a channel to a particular range, read the switch positions as UP or DN (down) from left to right in the

row beside the range you want to set. The switch shown in Fi is configured for ±5V range (switch

settings UP>DN>DN>UP>DN>DN).

Installing the CIO-DDA06

After you configure the board's switches and jumpers, you can install the CIO-DDA06 into your computer. To

install your board, follow the steps below.

Install the MCC DAQ software before you install your board

The driver needed to run your board is installed with the MCC DAQ software. Therefore, you need to install

the MCC DAQ software before you install your board. Refer to the Quick Start Guide for instructions on

installing the software.

Turn your computer off, open it up, and insert your board into an available ISA slot.

Close your computer and turn it on.

To test your installation and configure your board, run the InstaCal utility you installed in the previous

section. Refer to the Quick Start Guide that came with your board www.mccdaq.com/PDFmanuals/DAQ-

Software-Quick-Start.pdf for information on how to initially set up and load InstaCal.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 20 21

No comments

Measurement-computing CIO-DDA06 User Manual Page 12