Measurement-computing Protective Ears User Manual download pdf

Installing and Operating Protective Ears

Unit-to-Unit Attachment

For applications that are generally undisturbed, simply stacking the

product enclosures causes a modest engagement where the

bottom rubber feet of the top unit fit into the recesses of the lower

unit. No additional assembly is required.

Unit-to-Unit Attachment

pg. 1 of 2 909094 p/n 1102-0940 rev 3.0

Temporarily stack the

units to develop a

configuration that best

suits your application.

For all but the top-most

unit, deploy the 4 Splice

Tabs on each ear,

following steps 1-4, in

sequence, as shown in

Figure 1.

Restack the units

as shown in

Figure 2.

For each ear: remove the spare

#8-32 x 5/16 “screw from its

screw-hold and relocate it as

shown in Figure 3. Tighten the

screw snug.

Attaching a Handle

One or more handles can be applied to a single unit or to a stack of

units. The handle is affixed with two # ¼-20 x 7/8” screws (included

with the handle). For stacked systems, the handle should be

attached near the center of the stack to achieve reasonable

balance.

Attaching Ears to an Enclosure

Should you need to add or replace a protective ear, use the chart

on page 2 to identify the kit associated with your device; then follow

the steps for type “A” or type “B” as applicable. Note that all newer

data acquisition devices are shipped with protective ears already

attached.

Attaching Protective Ears

Type A Ears (see chart on back)

Figure 1

Figure 5

Type B Ears (see chart on back)

Since Type B ears have no hook to grasp the front and back

panel edge, simply place each ear on the side panel, line up

the screw holes and apply two #8-32 x 3/8” machine screws.

For each of the 4 ears follow steps 1-4 in Figure 6.

Figure 6

* Pivot the tab upright if you will be attaching a unit, otherwise you

can pivot the tab to be flush with the protective ear.

Turn the unit upside down. For each ear, apply a rubber foot

(included) into the recess, as shown in Figure 7.

Figure 7

1 2

Summary of Contents

Page 1 - Figure 7

Installing and Operating Protective Ears Unit-to-Unit Attachment For applications that are generally undisturbed, simply stacking the product enclosu

Page 2 - pg. 2 of 2

Usage Exceptions DaqBook/260, LogBook/360, and DBK60 p/n 1102-0940 rev 3.0 909094 pg. 2 of 2 Protectiv

Comments to this Manuals

No comments

Measurement-computing Protective Ears User Manual

Browse online or download User Manual for Hardware Measurement-computing Protective Ears. Measurement Computing Protective Ears User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Hardware Measurement-computing Protective Ears