67/,7(3&,76DWHOOLWH6HULHV3&,([SDQVLRQ6\VWHPUser’s ManualRevision 2 Copyright February, 2001
64 POWERING-UP/DOWN4.1 SEQUENCE FOR APPLYING POWERIt is important that higher-numbered PCI buses in your system’s hierarchy be powered-up and at a st
7The first expansion chassis also has a bridge. Its primary side is connected to Bus 1 and its downstream side isattached to Bus 2 on the chassis moth
8All of this not withstanding, bus numbering is determined by the algorithm implemented by your BIOS orconsole firmware configuration code. The labeli
96 SATELLITE MONITOR SOFTWARE INSTALLATION AND USEIncluded with the Satellite expansion chassis is the Satellite Parametric Monitor Application for m
10Each Satellite device is identified by its model name and secondary bus number included in the title bar of eachwindow.To view or activate each Sate
116.3 EXAMPLE PROGRAMSIncluded with the Satellite Monitor are example programs written in C/C++, Visual Basic (v5.0 and later), andDelphi (v3.0 and la
12previously programmed as input-only are not driven.Bits 4-7 of this register operate as “Write-1-To-Set.” Writing a “1” to any bit in the upper nib
138 SPECIFICATIONS8.1 STLITE-PCI-HOSTTypical for 25°C unless otherwise specified.Power consumption+5V 375 mA maxFeaturesBridge Industry standard brid
14Connector Pin OutPin Signal Name Pin Signal Name1 GND 41 HST_S_AD002 HST_5V 42 HST_S_AD013 GND 43 HST_S_AD024 PWR_MON 44 HST_S_AD035 GND 45 HST_S_AD
158.2 STLITE-PCI-8T, STLITE-PCI-8T+Typical for 25°C unless otherwise specified.FeaturesSlots 8 PCI slots: 4 full-length PCI, 4 half-length PCIPCI Bus
2LIFETIME WARRANTYEvery hardware product manufactured by Measurement Computing Corp. is warranted against defects inmaterials or workmanship for the l
16System MonitoringSystem monitoring features can be accessed via VB/C++ example programs and DLL provided with theproduct.A/D Converter TLV2548, 8-ch
17Connector Pin OutPIN SIGNAL NAME PIN SIGNAL NAME1 GND 41 HST_AD002 PWR_MON 42 HST_AD013 GND 43 HST_AD024 PWR_MON 44 HST_AD035 GND 45 HST_AD046 HST_S
18For your notes
EC Declaration of ConformityWe, Measurement Computing Corp., declare under sole responsibility that the product:STLITE-PCI-8TPCI BUS EXPANSION CHASSIS
Measurement Computing Corporation16 Commerce Boulevard,Middleboro, Massachusetts 02346(508) 946-5100Fax: (508) 946-9500E-mail: info@measurementcomputi
3Table of Contents1 INTRODUCTION ...
4This page is blank.
11 INTRODUCTIONThe STLITE-PCI-8T is an expansion chassis having eight-slots for expanding the Peripheral ComponentInterconnect (PCI) local bus of a P
22 COMPONENTS – STANDARD SYSTEMThe STLITE-PCI-8T consists of the following major components (See Figure 2-1):Figure 2-1. STLITE-PCI-8T Major Compone
32.4 EXPANSION CABLEThe STLITE-PCI-8T is supplied with an STLITE-C-3 cable. This is a shielded three-foot cable for connectingthe host bridge card to
4of the cover. Use care not to damage the connection when lifting off the cover. You can temporarily disconnectthe cable connector if you wish. See Fi
5CAUTIONThe PCI expansion cable is a specially-fabricated cable having a sheath of shielding around the wire ribbon. It issomewhat stiff and can be da
Comments to this Manuals