Measurement-computing USB-1208LS User Manual download pdf (Page 8)

Chapter 2

Installing the USB-1208LS

What comes with your shipment?

As you unpack your USB-1208LS, verify that the following components are included.

Hardware

The following items should be included with your shipment.

 USB-1208LS

 USB cable

Documentation

In addition to this hardware user's guide, you should also receive the Quick Start Guide. This booklet provides

an overview of the MCC DAQ software you received with the device, and includes information about installing

the software. Please read this booklet completely before installing any software or hardware.

Unpacking

As with any electronic device, you should take care while handling to avoid damage from static

electricity. Before removing the USB-1208LS from its packaging, ground yourself using a wrist strap or by

simply touching the computer chassis or other grounded object to eliminate any stored static charge.

If any components are missing or damaged, contact us immediately using one of the following methods:

 Knowledgebase: kb.mccdaq.com

 Phone: 508-946-5100 and follow the instructions for reaching Tech Support

 Fax: 508-946-9500 to the attention of Tech Support

 Email: techsuppor[email protected]

For international customers, contact your local distributor. Refer to the International Distributors section on our

website at www.mccdaq.com/International.

Installing the software

Refer to the Quick Start Guide for instructions on installing the software on the MCC DAQ CD. This booklet is

available in PDF at www.mccdaq.com/PDFmanuals/DAQ-Software-Quick-Start.pdf.

Installing the hardware

Be sure you are using the latest system software

Before installing the device, run Windows Update to update your system with the latest HID and USB drivers.

To connect the USB-1208LS to your system, turn your computer on, and connect the USB cable to a USB port

on your computer or to an external USB hub that is connected to your computer. The USB cable provides power

and communication to the device. When you connect the USB-1208LS for the first time, a Found New

Hardware dialog opens when the operating system detects the device. Another dialog identifies the USB-

1208LS as a USB Human Interface Device. When this dialog closes the installation is complete. The device

LED should blink and then remain on, to indicate that communication is established between the device and

your computer.

If the LED turns off

If the LED is on but then turns off, the computer has lost communication with the USB-1208LS. To restore

communication, disconnect the USB cable from the computer, and then reconnect it. This should restore

communication, and the LED should turn back on.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 25 26

No comments

Measurement-computing USB-1208LS User Manual Page 8