Measurement-computing DAQLog Quick Start User Manual download pdf

Revision 2, April, 2012

DAQLog Quick Start

Install the software and hardware

Complete the following steps to install DAQLog and your LGR-5320 Series device.

1. Install DAQLog from the DAQLog CD.

2. Insert the blank SD card that came with your DAQLog device into the SD card slot on the device.

3. Connect the external power supply to the power connector on the device, and connect the device to a

USB port.

4. Connect channel 0 of the device to an analog signal source so the device acquires data in single-ended

mode.

5. Remove any other SD, SDHC, or flash drives that are installed in your computer.

Run DAQLog and add the SD card

Complete the following steps to run DAQLog and add the SD card.

1. Select Start»All Programs»Measurement Computing»DAQLog»DAQLog to run DAQLog.

2. Click Add SD card on the toolbar.

Click Continue in the first SD Drive Selection dialog box.

4. Click OK in the next SD Drive Selection dialog box.

5. The SD card displays in the SD Drives pane.

Configure a settings file

Complete the following steps to create a settings file on the SD card that configures a LGR-5320 Series

device to acquire analog data.

Make sure the SD card is selected in the

SD Drives pane

1. Click New Settings File on the toolbar to open the Configuring Logging Session dialog box.

In the Settings Target list, select the device to configure.

3. Enter example in the Name field, and click Next>> to open the Configuring Analog Inputs dialog

box.

4. Configure channel 0 as shown below, and clear all other Log checkboxes for the remaining analog

channels.

Click Next on the next two dialog boxes to accept the default settings for counter and digital inputs and

to open the

Configuring Acquisition Startup, Timing, and Duration dialog box (counter and digital

data is not logged in this example).

6. In the Post-Trigger row, enter 500 in the Scan Duration textbox and 1,000.0 in the Scan Rate

textbox and click

Next>> to open the Configuring Event Recording dialog box.

7. Clear all checkboxes in this dialog box and click Finish.

1 2

DAQLog Quick Start 1
*325588B-01* 2

Summary of Contents

Page 1 - DAQLog Quick Start

Revision 2, April, 2012 DAQLog Quick Start Install the software and hardware Complete the following steps to install DAQLog and your LGR-5320 Series

Page 2 - *325588B-01*

Measurement Computing Corporation 10 Commerce Way Norton, Massachusetts 02766 Tel: (508) 946-5100 Fax: (508) 946-9500 www.mccdaq.com QS DAQLog.docx

Comments to this Manuals

No comments

Measurement-computing DAQLog Quick Start User Manual

Browse online or download User Manual for Software Measurement-computing DAQLog Quick Start. Measurement Computing DAQLog Quick Start User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Software Measurement-computing DAQLog Quick Start