PC104-DAC06User’s ManualRevision 4January, 2001

is an analog ground and is the ground reference which should be used for all analoghookups.Possible analog output ranges are:Bipolar Ranges ±10V ±5Van

If frequent changes to signal connections or signal conditioning are required, pleaserefer to the information on the CIO-TERMINAL, CIO-SPADE50, CIO-MI

A0A1A2A3A4A5A6A701234567Where the numbers along the top row are the bit positions within the 8-bit byte andthe numbers and symbols in the bottom row a

The DAC06 contains 12 registers. Two registers control one D/A output. Theseregister functions are identical to the CIO-DAC series registers except t

5.0 SPECIFICATIONSPower consumptionIcc: +5V quiescent 130 mA typical, 180 mA maxIcc: +12V quiescent 50 mA typical, 75 mA maxIcc: −12V quiescent

EC Declaration of ConformityWe, Measurement Computing Corporation, declare under sole responsibility that theproduct:DescriptionPart NumberPC104-DAC06

Measurement Computing Corporation 10 Commerce Way Suite 1008 Norton, Massachusetts 02766 (508) 946-5100 Fax: (508) 946-9500 [email protected].

Your new Measurement Computing product comes with a fantastic extra — Management committed to your satisfaction! Thank you for choosing a Measurement

Table of Contents95.0 SPECIFICATIONS...74.0 CONTROL & DATA REGISTERS...63.7 CONNECTOR DIA

This page intentionally left blank.

1.0 INTRODUCTIONThe PC104-DAC06 is a six-channel analog output board. The analog outputs aredual-DAC AD7237s with each output buffered. The PC104-DA

of completeness, and will allow you to set the hardware configuration of the board ifyou do not have immediate access to InstaCalTM and/or your comput

Table 3-1. PC I/O AddressesSERIAL PORT3F8-3FFEGA2B0-2BFFLOPPY DISK3F0-3F7PARALLEL PRINTER270-27FSERIAL PORT3E8-3EFALT BUS MOUSE23C-23FCGA3D0-3DFBUS MO

Figure 3-2 shows the jumper block in each configuration. Place the jumper on the twopins closest to the word XFER for simultaneous transfer.Figure 3-

Table 3-2. Range Select JumpersJump Pins Range2-4, 3-5 +/-10V2-4, 5-6 +/-5V1-2, 3-5 0 to 10V1-2, 5-6 0 to 5V3.4 OUTPUT TRANSFER FUNCTIONSTo program a