Measurement-computing CIO-DAC08 User Manual download pdf (Page 13)

CIO-DAC08 User's Guide Installing the CIO-DAC08

Turn your computer off, open it up, and insert your board into an available ISA slot.

Close your computer and turn it on.

To test your installation and configure your board, run the InstaCal utility you installed in the previous

section. Refer to the Quick Start Guide that came with your board www.mccdaq.com/PDFmanuals/DAQ-

Software-Quick-Start.pdf for information on how to initially set up and load InstaCal.

Connecting the board for I/O operations

Connectors, cables – main I/O connector

The table below lists the board connector, applicable cables, and compatible accessory products.

Board connector, cables, and accessory equipment

Connector type 37-pin male D connector

Compatible cables

 C37FF-x

 C37FFS-x

 DFCON-37 (D-connector, D-shell, and termination pins to construct your

own cable)

Compatible accessory products with

the C37FF-x cable or C37FFS-x cable

CIO-MINI37

CIO-TERMINAL

Information on signal connections

General information regarding signal connection and configuration is available in the Guide to Signal

Connections (available at www.mccdaq.com/signals/signals.pdf).

Pinout – main I/O connectors

The CIO-DAC08 I/O connector is a standard 37-pin male D connector that is accessible through the PC/AT

expansion bracket.

-12V 19

GND 18

+12V 17

NC 16

NC 15

NC 14

NC 13

NC 12

NC 11

NC 10

NC 9

D/A OUT 7 8

D/A OUT 6 7

D/A OUT 5 6

D/A OUT 4 5

D/A OUT 3 4

D/A OUT 2 3

D/A OUT 1 2

D/A OUT 0 1

37 GND

36 +5V

35 LLGND

34 LLGND

33 LLGND

32 LLGND

31 LLGND

30 LLGND

29 LLGND

28 LLGND

27 LLGND

26 LLGND

25 LLGND

24 LLGND

23 LLGND

22 LLGND

21 LLGND

20 LLGND

Figure 6. I/O connector pin-out

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments

Measurement-computing CIO-DAC08 User Manual Page 13

Comments to this Manuals

Related products and manuals for Hardware Measurement-computing CIO-DAC08