Measurement-computing Micro 488/EX rev.2.1 User Manual download pdf (Page 7)

Table of Contents

Section 7 Peripheral Pass-Thru Operation Page

7.1 Introduction 7.1

7.2 Serial and IEEE Input Buffers 7.1

7.3 IEEE Data Transfers 7.2

7.3.1 Blind Bus Data Transfers 7.2

7.3.2 Controlled Bus Data Transfers 7.3

7.4 Serial Poll Status Byte Register 7.4

7.5 Use of Serial and Bus Terminators 7.6

7.6 IEEE 488 Bus Implementation 7.7

7.6.1 My Talk Address (MTA) 7.7

7.6.2 My Listen Address (MLA) 7.7

7.6.3 Device Clear (DCL and SDC) 7.8

7.6.4 Interface Clear (IFC) 7.8

7.6.5 Serial Poll Enable (SPE) 7.8

7.6.6 Serial Poll Disable (SPD) 7.8

7.6.7 Unlisten (UNL) 7.8

7.6.8 Untalk (UNT) 7.8

7.7 IEEE Address Selection 7.9

7.7.1 Listen Only Mode 7.9

7.8 IEEE to Serial Applications 7.10

Section 8 IEEE 488 Primer Page

8.1 History 8.1

8.2 General Structure 8.1

8.3 Send It To My Address 8.4

8.4 Bus Management Lines 8.4

8.4.1 Attention (ATN) 8.4

8.4.2 Interface Clear (IFC) 8.5

8.4.3 Remote Enable (REN) 8.5

8.4.4 End Or Identify (EOI) 8.5

8.4.5 Service Request (SRQ) 8.5

8.5 Handshake Lines 8.6

8.5.1 Data Valid (DAV) 8.6

8.5.2 Not Ready For Data (NRFD) 8.6

8.5.3 Not Data Accepted (NDAC) 8.6

8.6 Data Lines 8.7

8.7 Multiline Commands 8.7

1 2 3 4 5 6 7 8 9 10 11 12 ... 217 218

Comments to this Manuals

No comments