Measurement-computing CIO-DAS08-PGH User Manual download pdf (Page 16)

3.2.6 Isolated Grounds / Single-Ended Inputs

Single-ended inputs can be used to monitor isolated inputs, though the use of the differential mode will increase you system’s

noise immunity. Figure 3-9 below shows the recommended connections is this configuration.

Figure 3-9 . Isolated Grounds - Single-Ended Inputs

3.2.7 Isolated Grounds / Differential Inputs

Optimum performance with isolated signal sources is assured with the use of the differential input setting. Figure 3-10 shows the

recommend connections is this configuration..

Figure 3-10. Isolated Grounds - Differential Inputs

Isolated Signal Source

Connected to a Single-Ended Input

I/O

Connector

Input

Amp

To A/D

LL GND

CH IN

A/D Board





Isolated

signal

source

Input

Amp

To A/D

A/D Board

I/O

Connector

LL GND

CH High

CH Low

Signal Source

and A/D Board

Already Isolated.

Already isolated si

nal source

and A/D board connected to

a differential input.

GND

These

rounds are

electrically isolated.

10 K

10K is a recommended value. You may short LL GND to CH Low

instead, but this will reduce your system’s noise immunity.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 27 28

Comments to this Manuals

No comments

Measurement-computing CIO-DAS08-PGH User Manual Page 16

Comments to this Manuals

Related products and manuals for Hardware Measurement-computing CIO-DAS08-PGH